Not able to restart sequence job

[palak08]

Hi all,

I have created one sequence with all necessary settings to make it restartable.
My sequence design look like:

Seq1--->Seq2

When my Seq2 aborts then it shows status as aborted/restartable. But when I restart it I get following message "sequence is not in runnable state"

When I compile it, it again start from seq1.

What am I missing here? What should I do so that after restart my sequence run from Seq2?

Any help will be much appreciated.

[chulett]

So... the same problem you've already posted here:

viewtopic.php?p=385020