passing muliple parameter set and value file combinations

nagarjuna · Post by **nagarjuna** » Fri May 21, 2010 1:40 pm

I have not tried but conceptually you cannot do that .Its as good as passing each parameter twice .

Bill_G · Post by **Bill_G** » Fri May 21, 2010 1:46 pm

nagarjuna wrote:I have not tried but conceptually you cannot do that .Its as good as passing each parameter twice .

I have my parameters divided between static and dynamic parameters. the values files can change based on geographic region. the job uses both the static parameter set and the dynamic. the parameters are not the same in both parameter sets.

nagarjuna · Post by **nagarjuna** » Fri May 21, 2010 2:06 pm

Do you mean to say that the parameter sets that you are passing are different ? Then its possible .You can pass as many parameter sets as you can .But you should not have the common parameter between these parameter sets . The value files are nothing but instances of these parameter sets .

Bill_G · Post by **Bill_G** » Fri May 21, 2010 2:18 pm

Exactly. you have it.

So looking at my syntax to pass muliple parameter sets... is that correct?

Thanks

Bill