Mistaking Warning Message

ninsekh · Post by **ninsekh** » Fri Feb 12, 2010 6:06 am

Hi everybody,

Please i would like to understand this warning Message:<<Attempting to Cleanup after ABORT raised in stage >>.

Thanks to help me to resolve this problem.

ArndW · Post by **ArndW** » Fri Feb 12, 2010 6:28 am

That message is always displayed as an effect of another error, it just means that the system is trying to clean up after itself after an error has occurred. Check your logs for the actual error.

chulett · Post by **chulett** » Fri Feb 12, 2010 7:33 am

Right... in a Server job that message is logged by the active stage which usually means the Transformer is named in it but that doesn't mean the problem lies there. And as Arnd noted, all it means by itself is that the job aborted, something you already knew.

There should be other messages logged with more information. Or you may need to Reset the aborted job and get that additional information from the 'From previous run...' log message that the reset adds to the log. Or both.

ninsekh · Post by **ninsekh** » Fri Feb 12, 2010 7:41 am

Ok!! I repeat running of my job and get the trully warning message:<< Abnormal termination of stage JOB_SERVER_NAME.NAME_OF_STAGE detected.>>

I don't know the meaning of this message. Please help me....

chulett · Post by **chulett** » Fri Feb 12, 2010 7:58 am

Yes, you do know the meaning because you read what Arnd and I posted... right? And if you read them, you'll know what needs doing to get more help.

ninsekh · Post by **ninsekh** » Fri Feb 12, 2010 8:51 am

I Talk about error wich is behind the warning message.

Sreenivasulu · Post by **Sreenivasulu** » Fri Feb 12, 2010 9:04 am

In Brief: This error would be something very straightforward

Regards
Sreeni

chulett · Post by **chulett** » Fri Feb 12, 2010 9:38 am

ninsekh wrote:I Talk about error wich is behind the warning message.

So do we. Are there any other warning messages logged? If you reset the aborted job is there a 'From previous run...' message added to the log? If so, post the contents of it.

ninsekh · Post by **ninsekh** » Mon Mar 01, 2010 1:16 pm

Hi!

I resolve this problem executing the command CLEAR.FILE &PH& throug the datastage administrator module.

Thanks for Us!!

chulett · Post by **chulett** » Mon Mar 01, 2010 2:42 pm

Well... we're be here when you come back. I sincerely doubt that would be all the fix you need but time will tell.