I modified a standardization QStage job. Added two extra columns to be o. When I run the QS job it runs as expected. However, when I run the sequencer that calls the QStage job. I get the error below. The sequencer didn't change but I recompiled it just in case.
Sqnc1DailyHHStgExt..JobControl (@QS_STANALL): Executed: /edw/di/ext/Edw1Dev/script/ExQsJobs HHDAILY STANALL
Reply=0
Output from command ====>
stty: tcgetattr: A specified file does not support the ioctl system call.
ERROR: osh is unavailable. Please install or configure
Op Failed osh (1)
/edw/di/proj/Edw1Dev
OSH unavailable error
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
-
- Participant
- Posts: 15
- Joined: Fri Mar 09, 2007 8:22 am
FYI - a good angst reliever, once you've discovered your mistake and copied the post into the correct forum, is to go back and delete the errant ones. You are allowed to do this with anything you post (topic starter or reply) as long as there are not replies to it.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers