DSXchange

Hi,
I have 3 jobs in a sequencer Job. I noticed that if the 2nd job of the 3 fails, the sequencer finishes successfully with some info on the Job that failed and it does not run the following jobs. Is there a way to make it a failed sequencer job if any of the job fails and if i want to restart it, is there a way to restart the job from the one that failed? so it does not restart from the previous ones that were successful.

Thanks.

You need to do something to directly cause it to fail.

One possibility is to output a failure link from each job to each routine
stage which calls UtilityAbortToLog() function.

-T.J.

>I have 3 jobs in a sequencer Job. I noticed that if the 2nd job of the 3
>fails, the sequencer finishes successfully with some info on the Job that
>failed and it does not run the following jobs. Is there a way to make it a
>failed sequencer job if any of the job fails and if i want to restart it,
>is there a way to restart the job from the one that failed? so it does not
>restart from the previous ones that were successful.

_________________________________________________________________
Is there a gadget-lover on your gift list? MSN Shopping has lined up some
good bets! http://shopping.msn.com