DSXchange

Hi,


When I try to load data into SAP using the idoc load stage I get the following SAP error:

EDI: Partner profile not available

I use the LSMW profile but apparently it is not enougth since LSMW is looking for US sender type and Datastage by default is LS.

What do I have to do in order to recognize datastage as a logical system.
Do I need to set up a new logical system for DataStage ?
What is the RFC type required for this logical system ?

I know this question is on the borderline between SAP and datastage but any assistant will be appreciated since it will help me comunicate with the basis people.


Thanks,
Amos

Open the IDOC load stage, under Stage > General tab, select "Properties..." from the dropdown list of Name.

In the pop-up screen, select the "IDoc Load Settings" tab, look at the value u enter for "Partner Number to Use when Sending IDocs". And make sure this Partner Number is maintained under SAP-Partner Profiles (WE20) too.

Hi

It's an old issue, already found this
It is not nice of them to hide properties

thanks