IDOC load

[Amos.Rosmarin]

Hi,


When I try to load data into SAP using the idoc load stage I get the following SAP error:

EDI: Partner profile not available

I use the LSMW profile but apparently it is not enougth since LSMW is looking for US sender type and Datastage by default is LS.

What do I have to do in order to recognize datastage as a logical system.
Do I need to set up a new logical system for DataStage ?
What is the RFC type required for this logical system ?

I know this question is on the borderline between SAP and datastage but any assistant will be appreciated since it will help me comunicate with the basis people.


Thanks,
Amos

[tomato]

Open the IDOC load stage, under Stage > General tab, select "Properties..." from the dropdown list of Name.

In the pop-up screen, select the "IDoc Load Settings" tab, look at the value u enter for "Partner Number to Use when Sending IDocs". And make sure this Partner Number is maintained under SAP-Partner Profiles (WE20) too.

[Amos.Rosmarin]

Hi

It's an old issue, already found this
It is not nice of them to hide properties

thanks