Page 1 of 1
Abnormal termination of stage
Posted: Wed Feb 08, 2006 5:28 am
by chitu_pathak
Hi,
I am using DataStage 7.1r1 along with EPM, while testing my batch Sequences job together, I am encountering only the following error in the LOG:
Abnormal termination of stage job
and then the job aborted...
But When I am running the same server job individually, it runs sucessful..
Any help will be really appreciated
Thanks
Posted: Wed Feb 08, 2006 5:45 am
by kumar_s
Welcom Aboard :D
Pls let know, if any other job gets aborted with any useful information by that time.
What is the information log before before this fatal error msg.
How many jobs been called together?
-Kumar
Posted: Wed Feb 08, 2006 5:46 am
by ArndW
When you do a job reset in the director you should see a new log entry with the title "from previous run..."; this often contains additiional information about the cause of an abort. Is the job you are running a multi-instance job and does the error occur every run?
Re
Posted: Thu Feb 09, 2006 4:01 am
by chitu_pathak
No I am not getting any additional information in the log ...
Is it becoz of running many parallel batch Sequences together,
the DW server gets loaded.. so it throws this kind of error, since I have tested all this batch jobs in my development environment...
Have any of you encoutered this before.. also my DW server speed is too slow..
Chitu
Check u have done the parameter settings properly
Posted: Tue Feb 14, 2006 5:34 am
by bgs_vb
Hi Chitu,
Please Check whether u have entered parameters values correctly and compiled all your jobs.
Check whether u r able to open a job in a sequence and able to get the values of source table. (ie, view data in the DRS stage)
Vindy