DSXchange

Hi All,
I have a job which uses BW load pack as target. Source is Oracle.
The same job runs fine without any warning or error in Dev and Quality Environment. But in Production it gives me an error and job aborts.

ERROR: Timeout waiting for BW to indicate InfoPackage ready for load

Also I get warning during the load which I never got so far in D and Q environment

WARNING load packet size 1000 less than 10000

Please advice with your valuable suggestions.

Thanks,
SM

HI ,

Did you find the solution for this problem,.Iam also facing the same problem now.
Can you kindly reply back if you have a solution

saadmirza wrote:Hi All,
I have a job which uses BW load pack as target. Source is Oracle.
The same job runs fine without any warning or error in Dev and Quality Environment. But in Production it gives me an error and job aborts.

ERROR: Timeout waiting for BW to indicate InfoPackage ready for load

Also I get warning during the load which I never got so far in D and Q environment

WARNING load packet size 1000 less than 10000

Please advice with your valuable suggestions.

Thanks,
SM

Checked their posting history and their last post was three years ago, so don't hold your breath. Just exactly how 'same' is your problem? I'd suggest you start your own post, with your details and messages and then see if anyone can help.

HI,

Under the server (where DS server been installed) you must find a folder for BW connections.
Select the source sys of your BW connection.
you must find a file which ends with .started
delete that file and run your loading job again.
It will suceed.
you cannot find this . started file for succesful loads