DSXchange

Hi ,
When a job failed due to some reason..and when the sequencer is re-launched again next time, I get this error...
seqXXX..JobControl (@seqXXYY): Controller problem: Error calling DSRunJob(seqXXYY), code=-14
[Timed out while waiting for an event]

It runs fine only If I compile that specific job and run again..
I wonder If I check the option 'reset if required and then Run'..why it wont work..?
how can we handle this..? any clue..

Do you have any 'wait for file' stage in it?

No I dont have any such stage..

Is the "timeout waiting to start" reliably reproducible?
What other load is on the machine at the time?