DSXchange

Hi!!

Is it possible to set number of rows after which stages are stoped, but I want to set it just one time, I don't want to set it every time when I run job. Also I don't want to use @OUTROWNUM in transformer stage. Is in DS sth like default value for number of rows limit (like there is for job parameters)

Regards

LUK,

the limit defaults to "no limit", so each time you want to limit a run you would need to specify that in the director's run box.

the limit defaults to "no limit", so each time you want to limit a run you would need to specify that in the director's run box.

Yes I know, but my question is: can I set limit default to i.e. 1000 (instead of "no limit" ??

is it possible??

Luk - I should have kept my response simple. The answer is "NO"

thanks Arnd !! I like simple and concrete anwsers !!

regards

The answer is actually YES, slightly longer than Arnd's answer.

In Director, go to Tools > Options and you will find that you can change the default values for limits there.

I thought I had missed something Thx.

And if you choose to run via a batch job then you can set the warning limit via the api.