Page 1 of 1
Jobs timeout
Posted: Mon Feb 09, 2004 7:08 am
by powerinmind2
Hi all,
i've a problem. I launch a DS parallel job. This job return an error code -"14 DSJE_TIMEOUT"
Can i set an option for increment the job timeout????
Help me pls!!
Massimiliano
Posted: Mon Feb 09, 2004 7:50 am
by chulett
Perhaps
this post over in the PX forum will help?
Posted: Mon Feb 09, 2004 8:11 am
by powerinmind2
chulett wrote:Perhaps
this post over in the PX forum will help?
Hi Craig,
i have send my problems in PX forum.....i hope that someone help me!!
Re: Jobs timeout
Posted: Mon Feb 09, 2004 9:44 am
by Sohail
powerinmind2 wrote:Hi all,
i've a problem. I launch a DS parallel job. This job return an error code -"14 DSJE_TIMEOUT"
Can i set an option for increment the job timeout????
Help me pls!!
Massimiliano
There is a parameter in the server for Inactivity timeout, check that and increase it to higher number. Hope this will help.
Re: Jobs timeout
Posted: Mon Feb 09, 2004 10:33 am
by powerinmind2
Sohail wrote:powerinmind2 wrote:Hi all,
i've a problem. I launch a DS parallel job. This job return an error code -"14 DSJE_TIMEOUT"
Can i set an option for increment the job timeout????
Help me pls!!
Massimiliano
There is a parameter in the server for Inactivity timeout, check that and increase it to higher number. Hope this will help.
Hi!!
Tks for your help but, i not found the param that you write to me!!
Are u sure for this param?
Massimiliano
Re: Jobs timeout
Posted: Mon Feb 09, 2004 10:40 am
by Sohail
Go into the DataStage Administrator, and increase the inactivity timeout, so you wait longer. You can also set it to not to timeout.
For the changes to go into effect, you will need to restart the DataStage engine
Re: Jobs timeout
Posted: Mon Feb 09, 2004 11:23 am
by powerinmind2
Hi Sohail!
Tks for your help. Unfortunately my problems is another!
Increase the inactivity timeout from DS Administrator is for connection client-server. This isn' my problem.
Excuseme if i haven't speak fine.
My problem is:
1. I launch a DS parallel job named "X".
2. I can launch the same DS parallel job named "X" while the first launch is running!!!
3. The second launch wait that the DS parallel job finish.... but the timeout for waiting job is low and the second launch return error "14 DSJE_TIMEOUT"!!!
4. I want, if possible, increment the JOB TIMEOUT!
I hope that this is possible!
Massimiliano
Sohail wrote:Go into the DataStage Administrator, and increase the inactivity timeout, so you wait longer. You can also set it to not to timeout.
For the changes to go into effect, you will need to restart the DataStage engine