Page 1 of 1
Posted: Tue May 20, 2003 7:58 am
by WoMaWil
You can write a job which reads your file and starts your next job with the parameters read in the file.
Wolfgang Huerter
=====================
Cologne, Germany
Posted: Tue May 20, 2003 8:25 am
by knvenkat
Hi Mr.WoMaWil,
So Its not possible to set Parameter file in properties like in Informatica?
Regards,
[:)]
Posted: Tue May 20, 2003 12:55 pm
by datastagedummy
Does any body has an example where they are passing the name of the Source file in a batch as being read from a list in a flat file ?
So If I have a flat file Named SourceFiles.txt containing
FileName1
FileName2
......
FileNameN
And I want to run the Job JobName n times depending on the file SourceFiles.txt
Posted: Tue May 20, 2003 3:57 pm
by mnevotti
Would eldonp's posting titled "Dynamic parameters in sequencer" help?[:)]
-Melinda
Posted: Wed May 21, 2003 4:35 am
by shiva459
Hi Syam
You can pretty well write a parameter file in datastage.Go to Job Properties and select the Parameters file where you can specify all the parameters.Embed that parameter in # at the fiels you want to use them.
Shiv
Shivakumar