Page 1 of 1
Posted: Thu Mar 06, 2003 8:01 am
by chulett
Hard to follow exactly what you mean. For example, by "temporary sequential file", are you saying that if you add a SEQ stage between *every* transform, essentially writting all rows to disk and then reading then back in between transforms, then it *works*? [?]
I've seen differences in behaviour between Director and Debugger in the past, but it's been a looong time. What version of DataStage are you running, and what is your platform?
-craig
Posted: Thu Mar 06, 2003 5:46 pm
by chulett
That's not right... have you contacted Ascential support on this? I also got notified that 6.0.1 has been released, might be worth getting your hands on it to see if it helps.
Sorry I couldn't be more helpful, but your problem sure seems more like a bug than doing something wrong.
-craig
Posted: Mon Mar 10, 2003 7:18 pm
by mihai
If you are moving files between operating systems, it may be worth making sure the line terminators are what you expect them to be...
Kind regards,
Mihai
_________________________
desk direct:+441908448571
Posted: Thu Mar 27, 2003 6:52 am
by ldesilvio
Hi,
Try going to the Performance tab in Job Properties of the job. This is the active-to-active link performance section. Make sure you have the following selected:
Enable row buffer
In Process
128kb buffer
I think the reason for your problem is that your going from active-to-active stages with either no row buffering or inter processing. This is why when you "land" the data in intermediate sequential files, it comes out correctly. Anyway, give that a try. I think that will solve the problem
LD
Posted: Thu Mar 27, 2003 5:16 pm
by ray.wurlod
Is the "omit last new-line" setting (on the Format tab of input link to Sequential File stage) enabled anywhere?
Or, are you sure that there IS a final new-line (at the end of the original input file)?
Ray Wurlod
Education and Consulting Services
ABN 57 092 448 518