DSXchange

Hi,

I'm getting the following error when I run the job in Quality.

Abnormal termination of stage Jobname..<transfomer stagename> detected

Even when I reset the job I'm getting the same error. This problem was not there in development and it surfaced only when we moved the code to quality.

Thanks,
Abhinav

When you Reset the aborted job, is there an entry added to the log that says "From previous run..."? If so, post the contents.

What other warnings were logged?

When I looked at the previous run after resetting, it said fault type 11. I searched through the forum and found a lot of similar errors.

I finally figured that jobs were aborting because the connection to Sybase was not properly setup. I asked our admin to fix it after which the jobs started running properly.

Thank you all for your help.