Page 1 of 1
MQseries stage add to installation
Posted: Sat May 14, 2011 6:57 am
by JeroenDmt
During installation the checkbox 'Install WebSphere MQ Plug-in'
(WebSphere MQ Server) was left unchecked. However we do need the MQ
stage (not the new connector).
How can we add this to the current installation? (Information Server
8.5)
Posted: Sun May 15, 2011 7:14 am
by chulett
In the pre 8.x world, you'd have to repeat the installation and it would go into "maintenance mode", allowing you to add any missed optional plug-ins as one of the options. I don't believe that's the case for 8.x but unfortunately don't know off the top of my head what the new procedure might be.
If no-one pops in here with instructions, contact your official support provider and then let us know the answer.
Posted: Mon May 16, 2011 12:58 am
by JeroenDmt
Yes, I was hoping that would still work, but when you re-start the installation program, you can add tiers or add products, but unfortunately it does not bring you back to that MQ plug-in checkbox.
Posted: Tue May 17, 2011 12:12 am
by JeroenDmt
There is a utility dscompinst to install or uninstall plugins after the initial installation.
You can add the MQseries plug-in using:
..\IBM\InformationServer\Server\DSComponents\bin\dscompinst -username <admin-user> -password <password> -locale en_US -install -force ..Install_executables\InfoSvr_v8_5_Wdws_64\is-suite\payloads\DataStageCommon\PluginStages\payload\mqseries.jar -log \tmp\installMQ.log
Posted: Tue May 17, 2011 6:33 am
by chulett
Good to know, thanks for posting that.
