Page 1 of 1
Running only selected jobs in same template
Posted: Thu Jun 10, 2010 4:45 am
by arnie_nits
HI,
Is it possible to run only selected jobs under 1 template.
Regards,
Arnie.
Posted: Thu Jun 10, 2010 4:49 am
by ArndW
Could you explain what you mean by 'same template'?
Posted: Thu Jun 10, 2010 5:51 am
by chulett
Assuming that means a Sequence job, the answer is no - at least from the Sequence itself. You could, of course, run them individually from the Designer... or perhaps build a temporary Sequence with just the bits you need.
Posted: Thu Jun 10, 2010 12:24 pm
by arnie_nits
By template I mean the place where we create the jobs. Imagine I have 2 independent jobs in that(2 jobs in 1 background). But I want to run only 1 and not the other. Is it possible??
Regards,
Arnab.
Posted: Thu Jun 10, 2010 12:32 pm
by anbu
Yes you can run one job separately
Posted: Thu Jun 10, 2010 4:20 pm
by ray.wurlod
Designer is a multi-document interface, so you can have more than one job design open at once and run only one of those.
On the other hand, if you have two data flows in one job, there is no way to run just one of those unless you include parameterized constraints in each flow.