Page 1 of 1
Job Aborted after 1 errors logged
Posted: Wed Aug 19, 2009 12:49 am
by MURALI123
Hi All,
i have got the below fatal error with warnings can anybody suggest me how can solve that
Fata errror:Job Aborted after 1 errors logged
warnings: (1)Abnormal termination of stage Jobname.x detected
(2)Attempting to Cleanup after ABORT raised in job jobname.x
Regards,
Malli
Re: Job Aborted after 1 errors logged
Posted: Wed Aug 19, 2009 2:00 am
by sachin1
please can you give more information from director log for further analysis of your problem.
Posted: Wed Aug 19, 2009 2:21 am
by Sainath.Srinivasan
Do you have any transformer set with abort after 1 rows option enabled ?
Posted: Wed Aug 19, 2009 2:26 am
by dxk9
Can you tell me the rough flow of your job (like what stages are used) ?
Posted: Wed Aug 19, 2009 3:24 am
by priyadarshikunal
also check in director if the warning limit is set to 1.
If you are starting it from dsjob then have you used "-warn 1".
Posted: Wed Aug 19, 2009 3:34 am
by dxk9
You can try any of the following depending upon your need.
a. When you run the job ( from director/designer), the "Job run options" dialogue box will appear. In that choose the "Limits" tab, and select "No limit" option. This will stop your job from aborted unless there is a fatal error.
b. Open the job's log, then choose View->Filter Entries option, then check if all the Type are checked. This will enable you to view all the log irrespective of what type it is.
Regards,
Divya