DSXchange

Hi , everybody !!!

I hae a job run by Job Sequence . Immediately after the job is finishing (It transfer all rows) and I get message : "Job <My Job Name > has finished, status = 97 (Stopped by operator)" . Because of it the whole my sequence failed.

I have tried to change job's name and recompile job and job sequence with no success.

Any ideas ?

Do you have an after-job routine defined?

No.

Is there anywhere (e.g. a routine, a Terminator) that might have issued a stop request?

Check the user that ran the job. Maybe it is a permission problem.

Check the log which says "summary of sequence run" to find which stage issued the stop request (If Any)