Job stops Immediately with no reason

snassimr · Post by **snassimr** » Sun Jun 21, 2009 3:45 am

Hi , everybody !!!

I hae a job run by Job Sequence . Immediately after the job is finishing (It transfer all rows) and I get message : "Job <My Job Name > has finished, status = 97 (Stopped by operator)" . Because of it the whole my sequence failed.

I have tried to change job's name and recompile job and job sequence with no success.

Any ideas ?

ArndW · Post by **ArndW** » Sun Jun 21, 2009 7:46 am

Do you have an after-job routine defined?

snassimr · Post by **snassimr** » Sun Jun 21, 2009 8:08 am

ray.wurlod · Post by **ray.wurlod** » Sun Jun 21, 2009 5:38 pm

Is there anywhere (e.g. a routine, a Terminator) that might have issued a stop request?

kduke · Post by **kduke** » Sun Jun 21, 2009 11:00 pm

Check the user that ran the job. Maybe it is a permission problem.

priyadarshikunal · Post by **priyadarshikunal** » Mon Jun 22, 2009 2:13 am

Check the log which says "summary of sequence run" to find which stage issued the stop request (If Any)