DSXchange

Hi All,

Can we set Warning limit in dsjob -run command?

I want to set it no limit.

Thanks
Deepa Kr Sharma

There is no mechanism for doing so.

If the project default (set in Director) is N, then the dsjob command will inherit this value. Set N = 0 if you want unlimited warnings.

Beware, though, that this can cause your log table to become very large which slows execution of your job hugely.

Actually there is, the same one you mentioned: dsjob -run -warn 0 Here zero equals unlimited as well. Usually a Bad Idea but that's how you would do it.