I have installed datastage client on my machine. When I am trying to connect to datastage server i am getting the below waring. Can anyone let me know what I should do to be able to connect to the server.
"Failed to connect to host: 10.1.3.89, project: UV
Invalid UniVerse mark characters have been sent from the server. Code page 874 may not support these characters, or you may need to install DataStage NLS."
I am able to connect to the server remotly and login to it. but I am unable to connect it through the datastage client.
Thanks in advance
Unable to connect to the server from client
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 132
- Joined: Wed Mar 01, 2006 11:12 pm
- Location: Pune
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Is NLS enabled? You are using a code page on your Windows client that does not correspond to that used on the DataStage server. Try setting each to 1252 and working from there.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 132
- Joined: Wed Mar 01, 2006 11:12 pm
- Location: Pune
Hi Ray,ray.wurlod wrote:Is NLS enabled? You are using a code page on your Windows client that does not correspond to that used on the DataStage server. Try setting each to 1252 and working from there. ...
Thanks for the reply. Can you tell me where to do this setting. and where to check if the NLS is enabled
SMB
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
-
- Participant
- Posts: 18
- Joined: Tue Oct 28, 2008 2:31 am