DSXchange

Is there a way to change the autopurge settings for all existing jobs in a project?

I know you configure the initial autopurge settings in Administrator for a project and those settings are used when a job is created (right?). However, after a job has been built and you want to change the autopurge settings, I've only found the option in Director under "Job -> Clear Log..." where you can change the settings for an individual job.

I see the [AUTO-PURGE] settings in DSParams. But I assume that is the file updated from Administrator since it is project wide?

Thanks. [I did not find anything via a search.]

You may want to check Kenneth Bland's website for a utility that he has developed. I have used it and it works wonderfully. You will have to register in his site to get to the tips and tricks (or is it the tools?) page.

Was just going to post the same thing. I could have sworn it was posted here, but couldn't find it. It used to be available at the old DataStageXchange site but is 'No longer available' there.

chulett wrote:Was just going to post the same thing. I could have sworn it was posted here, but couldn't find it. It used to be available at the old DataStageXchange site but is 'No longer available' there.

OK.. here is what Kenneth had to say -

viewtopic.php?t=106690

Thanks to all. Exactly what I needed. Figured someone had already done this before.

Thanks Gateleys. I'd searched for the KBA utility name, figured that would be included in any post with the code. When that didn't turn anything up and you posted, I stopped searching. Thanks for providing the link.