DSXchange

HI

I am not able to open the properties of any of the stages that are dragged to a sequence job.

Is it because of some settings in DataStage with which I am not able to open the properties of the sequence stages or anything else?

FYI. 1. I am able to open the stages in a normal server job. But not able to open the stages of a sequence. Can any one please help me in this issue.
2. The project is not in protected mode.

Thanks
Sai Krishna

If you're running DataStage on a Windows XP sp2 , you need xpsp2 client patch

saikrishna wrote:HI

I am not able to open the properties of any of the stages that are dragged to a sequence job.

Is it because of some settings in DataStage with which I am not able to open the properties of the sequence stages or anything else?

FYI. 1. I am able to open the stages in a normal server job. But not able to open the stages of a sequence. Can any one please help me in this issue.
2. The project is not in protected mode.

Thanks
Sai Krishna

Thanks a lot

It is working after the installation of the patch.

Hi,
The problem is bad installation .try to installation again and while installation check the drive file system type ,,,is in NTFS or not

Vinod, I guess you missed the part where they stated "It is working after the installation of the patch".