Server Sequence Compiled Error

atan003 · Post by **atan003** » Mon Nov 13, 2006 1:09 am

Hi,

There have 29 jobs and an User Variable Activity in the server job.

When I compiled, it was failed with a message as following:
"Error calling subroutine: DSR_RECORD (Action=2); check DataStage is set up correctly in project BISETL
(Internal Error (81021))"

But I don't know what is wrong.

loveojha2 · Post by **loveojha2** » Mon Nov 13, 2006 2:38 am

Are you using the omit option while logging into the datastage, if yes, try with username/passwd and re compile.

atan003 · Post by **atan003** » Mon Nov 13, 2006 2:43 am

Yes, and it is OK.

Thanks.

ray.wurlod · Post by **ray.wurlod** » Mon Nov 13, 2006 7:31 am

Was this when you were compiling the job sequence, or a server job? Part of compiling a job sequence occurs on the client, and error codes in the 81xxx range relate the the DataStage RPC mechanism. Does this error occur reliably, or did it occur only once? If the former, check that you have write permission in and below the folder where the DataStage client is installed.

dannyna · Post by **dannyna** » Tue Nov 14, 2006 2:54 am

Hi,

I had similar problems.
It appeared to have nothing to do with the DS but to network problems.

Danny

DSXchange

Server Sequence Compiled Error

Server Sequence Compiled Error

Yes, it is OK, Thanks