Hello
I was reading through Parallel JobDeveloper Guide.
I have few questions.
1. If I design for a multiprocessor architecture say (Partition parallel processing) for 4 CPU Units.Then I upgrade my system to 8 CPU unit system, but i failed to update my Configuration File!!!
will the JOB use 4 processors or 8 processors?
Regards
pramod
Pramod
Parallel Processing
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Depends.
It will initially use four CPUs, because you haven't updated the configuration file.
However, and depending on how your actual jobs are designed, any single job may run in more than one process, and the operating system scheduler may or may not choose to assign these to the other CPUs.
I would not rely on this, though; I'd update my configuration file.
Ray Wurlod
Education and Consulting Services
ABN 57 092 448 518
It will initially use four CPUs, because you haven't updated the configuration file.
However, and depending on how your actual jobs are designed, any single job may run in more than one process, and the operating system scheduler may or may not choose to assign these to the other CPUs.
I would not rely on this, though; I'd update my configuration file.
Ray Wurlod
Education and Consulting Services
ABN 57 092 448 518