ABNORMAL TERMINATION

karry450 · Post by **karry450** » Wed Nov 18, 2009 6:40 am

Hi

I have imported the etl code from .dsx file from dev environment to UAT environment.

But when I run the job I getting this error

"Abnormal termination of stage Parameter_File_Job..tDefaults_Parameterfile detected"

But when I compile the job after it got aborted from the designer and run again it runs successfully.

I got the below error when I reset the job after it got aborted can any one help me please.

"From previous run
DataStage Job 1 Phantom 6937
DataStage Phantom Finished."

"From previous run
DataStage Job 1 Phantom 6947
Abnormal termination of DataStage.
Fault type is 11. Layer type is BASIC run machine.
Fault occurred in BASIC program DSP.Open at address 574."

Can Any one help me please

chulett · Post by **chulett** » Wed Nov 18, 2009 6:45 am

Have you tried searching for "Fault type is 11. Layer type is BASIC run machine." yet? It turns up several matches. It may also help to fully describe your job.

karry450 · Post by **karry450** » Wed Nov 18, 2009 6:51 am

chulett wrote:Have you tried searching for "Fault type is 11. Layer type is BASIC run machine." yet? It turns up several matches. It may also help to fully describe your job. ...

But none of the posts helped me

chulett · Post by **chulett** » Wed Nov 18, 2009 7:32 am

And why is that?

You really haven't given us all that much to go on, btw. How about that job design?