Read Only dsx

chitravallivenkat · Post by **chitravallivenkat** » Thu Oct 08, 2009 10:45 am

Hi,

The .dsx code that is taken from protected environment has been installed in the development system, but now the code does not allow to modify as it is read only.

Is there any possible to make the code in a such way i can modify for development?

Regards,
Venkat

chulett · Post by **chulett** » Thu Oct 08, 2009 10:50 am

First thing to try - edit the .dsx file and change everywhere it says Readonly "1" to Readonly "0" and reimport it.

chitravallivenkat · Post by **chitravallivenkat** » Thu Oct 08, 2009 1:04 pm

chulett wrote:First thing to try - edit the .dsx file and change everywhere it says Readonly "1" to Readonly "0" and reimport it. ...

Thanks Chulett. Now I am able to modify the code.

Thanks once again.

Venkat