Hi,
I got this error:
Command failed to execute - ERROR: Failed to open project Status code =
81022.
I'm receiving this executing a job that monitors others, this happens when the job calls the dsjob -jobinfo command, in other occasions this job just hangs in the same point of execution; but the most of the time it is running ok.
Do you know what does it means this status code?
Thanks for your help.
Status code = 81022
Moderators: chulett, rschirm, roy
Re: Status code = 81022
Nobody knows what does it means this status code?
Please help me.
Thanks in advance.
Please help me.
Thanks in advance.
Status code = 81022
Thanks Craig,
No, this job it only extracts the status from other interfaces, it is scheduled through command Schtask to be executed after the last interface runs, even though we have detected there are many bats at the same time, with this scheduled should be enough to be executed at the end of the last one.
Do you know if we can generate the schedule through DS to run this job when the last interface has run?
No, this job it only extracts the status from other interfaces, it is scheduled through command Schtask to be executed after the last interface runs, even though we have detected there are many bats at the same time, with this scheduled should be enough to be executed at the end of the last one.
Do you know if we can generate the schedule through DS to run this job when the last interface has run?
Last edited by Elozm on Wed Sep 09, 2009 3:11 pm, edited 1 time in total.