Hi all,
One of my sequnce got aborted.
When i reset i got the below message from 'previous run..'
File 'E:\\EZTRAVELMIG\\EZTRAVEL/RT_LOG1043/DATA.30':
Computed blink of 0xA6C does not match expected blink of 0x0!
Detected within group starting at address 0x80000000!
Job Aborted after Fatal Error logged.
Could anyone help me in resolving this
Thanks in advance
Log file error
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
This is a corrupted hashed file, which contains the log for job number 1043. You can search the forum for ways to get out of this situation, depending on how badly you need the contents of the log. The address in the backward link error suggests that your log hashed file has tried to exceed its limit of 2GB.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
It will solve the "problem" of the corrupted job log, but it will mean that you lose any information already logged. If that is acceptable then the CLEAR.FILE command is the fastest fix.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.