Hi,
I am having a parallel job where i have hardcoded the value for $APT_CONFIG_FILE to use a single node config file. I am calling this job through a job sequence. The default config file for this project is set to 4 node config file.
When i run the job sequence, will the individual job run with 1-node config file or is there a method to run it in single node. Should i pass the environment variable's value through the sequencer?
Thanks
$APT_CONFIG_FILE value in individual job
Moderators: chulett, rschirm, roy
The explicit hard-coded value for APT_CONFIG will take precedence and that job will run with that config file.
<a href=http://www.worldcommunitygrid.org/team/ ... TZ9H4CGVP1 target="WCGWin">
</a>
</a>
-
- Premium Member
- Posts: 210
- Joined: Wed Feb 16, 2005 7:17 am
-
- Premium Member
- Posts: 210
- Joined: Wed Feb 16, 2005 7:17 am
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Always in parallel jobs add $APT_CONFIG_FILE as a job parameter with $PROJDEF as the default value of the job parameter.
If your configuration file includes node pools and/or disk pools, individual stages can be constrained to execute in these. In an SMP environment there's not a great deal of value in doing so but, in a multiple-machine environment, there definitely is.
If your configuration file includes node pools and/or disk pools, individual stages can be constrained to execute in these. In an SMP environment there's not a great deal of value in doing so but, in a multiple-machine environment, there definitely is.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.