I have a simple job
HashFile -> IPC-> Transformer->IPC->Hashfile.
This job is called as a after job sub routine. And the parameters are seem to be passing right. Any of you guys seen this error before? Any ideas what could be causing this?
Thank you.
DSU.ClearHashFile is not cataloged
Moderators: chulett, rschirm, roy
He did not ask you to recompile a job but to recompile the ClearHashFile routine. Is that what you did?Nagin wrote:I tried re-compiling the job I am still getting the same errornarasimha wrote:Re-compile your routine ClearHashFile and try if it works.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Another possibility is that the job was exported from another project and imported into this one but the routine was not, so that ClearHashFile does not even appear in the Repository. If this is the case, you must obtain the routine from wherever the job was exported from.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Yep, Ray nailed it. The routine was not imported along with the job and its not there in repository. I have imported the routine and re ran the job, it runs fine.ray.wurlod wrote:Another possibility is that the job was exported from another project and imported into this one but the routine was not, so that ClearHashFile does not even appear in the Repository. If this is the case, you must obtain the routine from wherever the job was exported from.
Thank you all very much.