HI,
I am using BAPI stage to write a record(Col1,Col2,Col3,Col4) into a BAPI,But the BAPI also returning a table structure(col_new1,col_new2,col_new13) as a return value after each record insertion.
I have successfully inserted a record into the BAPI table,but how could I get the return value immediately and write it into a file.
Logic will be as follows:
|Sequential stage| ---> |Transformer| ---> |BAPI Stage| ---> |Transformer| ---> |Sequential Stage|
Please correct me , If there are any mismatches.
Thanks
Ganta.
Return Value from BAPI
Moderators: chulett, rschirm, roy
-
- Charter Member
- Posts: 166
- Joined: Wed Mar 16, 2005 6:52 am
- Location: Mumbai, India
Hi,
Please refer to this Link:
<a href="http://dsxchange.com/viewtopic.php?t=93 ... 114f39fa6a"> LINK</a>
Basically If the BAPI is being used for Input the return table parameter(which is usually an output parameter) is treated by DataStage as an Input table parameter.
This can be checked out in the table parameters section in the BAPI Stage.
IHTH
Please refer to this Link:
<a href="http://dsxchange.com/viewtopic.php?t=93 ... 114f39fa6a"> LINK</a>
Basically If the BAPI is being used for Input the return table parameter(which is usually an output parameter) is treated by DataStage as an Input table parameter.
This can be checked out in the table parameters section in the BAPI Stage.
IHTH
Amey Vaidya<i>
I am rarely happier than when spending an entire day programming my computer to perform automatically a task that it would otherwise take me a good ten seconds to do by hand.</i>
<i>- Douglas Adams</i>
I am rarely happier than when spending an entire day programming my computer to perform automatically a task that it would otherwise take me a good ten seconds to do by hand.</i>
<i>- Douglas Adams</i>