Hi All,
I have a job which uses BW load pack as target. Source is Oracle.
The same job runs fine without any warning or error in Dev and Quality Environment. But in Production it gives me an error and job aborts.
ERROR: Timeout waiting for BW to indicate InfoPackage ready for load
Also I get warning during the load which I never got so far in D and Q environment
WARNING load packet size 1000 less than 10000
Please advice with your valuable suggestions.
Thanks,
SM
ERROR: Timeout waiting for BW to indicate InfoPackage ready
Moderators: chulett, rschirm, roy
Re: ERROR: Timeout waiting for BW to indicate InfoPackage r
HI ,
Did you find the solution for this problem,.Iam also facing the same problem now.
Can you kindly reply back if you have a solution
Did you find the solution for this problem,.Iam also facing the same problem now.
Can you kindly reply back if you have a solution
saadmirza wrote:Hi All,
I have a job which uses BW load pack as target. Source is Oracle.
The same job runs fine without any warning or error in Dev and Quality Environment. But in Production it gives me an error and job aborts.
ERROR: Timeout waiting for BW to indicate InfoPackage ready for load
Also I get warning during the load which I never got so far in D and Q environment
WARNING load packet size 1000 less than 10000
Please advice with your valuable suggestions.
Thanks,
SM
Checked their posting history and their last post was three years ago, so don't hold your breath. Just exactly how 'same' is your problem? I'd suggest you start your own post, with your details and messages and then see if anyone can help.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers
HI,
Under the server (where DS server been installed) you must find a folder for BW connections.
Select the source sys of your BW connection.
you must find a file which ends with .started
delete that file and run your loading job again.
It will suceed.
you cannot find this . started file for succesful loads
Under the server (where DS server been installed) you must find a folder for BW connections.
Select the source sys of your BW connection.
you must find a file which ends with .started
delete that file and run your loading job again.
It will suceed.
you cannot find this . started file for succesful loads