Shared container

reddy · Post by **reddy** » Fri Jun 17, 2005 8:23 am

Hi Guys,

I created a simple load job and made it as shared container,when i am trying to use that shared container in another job as a input what i observed is i couldn't see "MAP TO CONTAINER LINK",
Please advice me what i did wrong.

Thanks for help.

Thanks
Narasa

anupam · Post by **anupam** » Fri Jun 17, 2005 8:29 am

When u created the shared container, u created the output link also ?

i think the problem is the output link from the shared container

ray.wurlod · Post by **ray.wurlod** » Fri Jun 17, 2005 5:24 pm

This message can arise when the name of the link from the parent job to the container is not the same as the link connection within the container to the container input or output.
If you make the link names the same, this problem willl go away.
Otherwise, you need to right click on the container in the parent job and select "map to container link" from the pop-up menu. From memory, there are one or two releases where this option does not appear; that's a bug in the client, so you need the "same names" fix.

Ananda · Post by **Ananda** » Mon Jun 20, 2005 12:19 pm

MAP TO CONTAINER LINK:

Right click on the Shared Container and go to Properties.
In the Inputs tab select the link under Link mapping.

Note: This link is the same as the link to the common job component made available throughout the project.

This should solve the problem.

reddy · Post by **reddy** » Fri Jun 24, 2005 1:36 pm

Thanks alot sir.