I have a job that is marked as a muti-instance job (in the job properties). The job executes without any problems. However, when I try to invoke another instance of the job, it does not allow it (job is already running message). In the Director, the run button is greyed out.
Do I have to set this option somewhere else?
Multi Instance Job
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 3337
- Joined: Mon Jan 17, 2005 4:49 am
- Location: United Kingdom
-
- Premium Member
- Posts: 614
- Joined: Fri Feb 06, 2004 3:59 pm
-
- Participant
- Posts: 3337
- Joined: Mon Jan 17, 2005 4:49 am
- Location: United Kingdom
If you have indeed checked the box on the job properties named "Allow Multiple Instance" and have recompiled the job then you should see a drop down with a title called "Invocation Id" on the same tab as the parameters when you run the job. At this point you can assign an invocation id.
Mike Hester
mhester@petra-ps.com
mhester@petra-ps.com
And just to finish beating this little horsey...
If you are running the job outside of the GUI (via 'dsjob' for instance) supply the Invocation ID as a 'dot seperated' value after the job name. For example, run 'Jobname.ID' rather than 'Jobname'.
If you are running the job outside of the GUI (via 'dsjob' for instance) supply the Invocation ID as a 'dot seperated' value after the job name. For example, run 'Jobname.ID' rather than 'Jobname'.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers