Anyone experienced this before :-
where the Designer become no response when attempt to open properties for job activity in job sequence?
No response when attempt to open properties in JS
Moderators: chulett, rschirm, roy
Re: No response when attempt to open properties in JS
If it's consistent, try uninstalling your client and reinstalling it.ysweec wrote:Anyone experienced this before :-
where the Designer become no response when attempt to open properties for job activity in job sequence?
It may also be you have a "bad" version of DataStage. I remember that v6.0.1 had these kind of little bugs, later upgrades of v6 fixed this.
You seem to be able to upgrade client versions within the same major version of the server.
Ogmios
In theory there's no difference between theory and practice. In practice there is.
-
- Premium Member
- Posts: 385
- Joined: Wed Jun 16, 2004 12:43 pm
- Location: Virginia, USA
- Contact:
-
- Premium Member
- Posts: 385
- Joined: Wed Jun 16, 2004 12:43 pm
- Location: Virginia, USA
- Contact:
That may be so, but the readme is very general.
Unable to open sequencer stages with XP SP2 (ecase 60128)
=========================================================
The following stage editors are non functional on the
job sequencer canvas after the installation of Windows XP SP2.
job activity
routine activity
user variable activity
Applicability of patch
======================
This patch will patch release 7.5 of DataStage and earlier
versions. However if the unsupported client switcher from
earlier 7.x releases is installed then the 7.5 version of
the client switcher should be installed prior to applying
this patch.
Instructions for installing the patch for ecase 60128
=====================================================
The patch for ecase 60128 comprises a number of files
contained within a zip file called: DataStage_XPSP2_Patch.zip.
The patch is a client only patch for Windows XP SP2 only.
Install the patch as follows:
1) Create a temporary directory
2) Unzip the patch into the temporary directory
3) Run the setup.bat file, it will prompt for the installation
directory of the client. This MUST be quoted when entered.
Uninstallation
==============
The patch can be uninstalled by running the setup.bat script
with the option '/uninstall'. As before the client install path
must be quoted when entered.
Chuck Smith
www.anotheritco.com
www.anotheritco.com
From Ascential's eServices website. Under Software Updates / Downloads.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers