I though I could replace Seq File1.1 and Seq File2.1 with IPC stage. But when I did that the link with Seq File2.1 finished but the link with Seq File1.1 aborted giving an error for the merge stage "Error occurred while deleting temporary file".
Which is this temporary file that its referring to? Why such error does not happen when i write it into a sequential file?
chucksmith wrote:Do the two sequential files have the same number of rows. If not, I think this is a problem for the collector prior to version 7.5.
As of now, both the sequential files have different number of rows. But why do you think there would be a problem if there are same no. of rows in both the sequential files?
The link collector is working fine with the sequential files!!
At release 6 and perhaps early 7, the collector performed blocking reads. If an input link stopped supplying rows, or was delayed until the timeout was reached, then everything hangs.
If your number of rows is relatively close, I have been able to make this work, too.
chucksmith wrote:At release 6 and perhaps early 7, the collector performed blocking reads. If an input link stopped supplying rows, or was delayed until the timeout was reached, then everything hangs.
If your number of rows is relatively close, I have been able to make this work, too.
Which version of 7 are you using?
I know that I am using 7.0. But were you hoping to get more info?
I turned the Inter Process buffering "on" for this job and took out the IPC stages that I had between the transformer stages and the link collector. I connected the transformers directly to the Link Collector and ran the job.