DSXchange

Posted: **Sun Oct 07, 2007 7:16 am**

Hi,

I try to redo the Quality Stage 8.0 Essentials course. No problems until I want to test the passes within the Match Designer.

The error 'Match Designer Match Pass run failed' pops up. The Show Error(s) (OSHErrors.txt) and Show Full Log (OSHErrorLog.txt) are both empty.

Setting up the Test Environment using the QS-database reports no errors.

Does anyone have an idea ?

Posted: **Sun Oct 07, 2007 1:18 pm**

Not really. Make sure that you have configured the data source and the match passes accurately. Try moving one of the match passes into the holding area. If that works, try reinstating that one and moving the other into the holding area. In short, try to narrow the focus of your diagnosis to identify the stage that is causing the failure.

Posted: **Tue May 20, 2008 1:14 am**

Make sure your NLS in your project and database are the same.
Example : UTF8

Posted: **Fri May 23, 2008 2:39 am**

Install the fixpack then you will get the data in osherrorlog.txt and osherror.txt .

Posted: **Fri May 23, 2008 5:48 am**

Please add a post indicating, for future searchers, HOW this problem was resolved.