Ouptput question QS 7.5 vs QS 7.0

[daxinz]

I have both QS 7.5 and QS 7.0 server installed on different UNIX computers, and both client on my XP computer.
I import the Project from QS 7.0 client into QS 7.5.
I ran the matching process with the same setting as I did for QS 7.0, Same input files (copied) . All the setting are the same : cutoff, u-prob, m-prob, ....

I have 3 three output files (extract): match, dup, resdA. In QS 7.0 all the three out get records. match file get 3079873 records, and dup get 3407328 records.
But with QS 7.5, the dup file does not have records. math has 3577682 records.

Please forward instruction why the output is so big difference.

Thanks in advance.

[ray.wurlod]

Are you running these in the parallel engine or the server engine? If parallel, are the configuration files the same (contain the same number of nodes)?

[rjdickson]

Did you verify the Match Extract specification was not affected by the import into 7.5?

Also, did you select 'Extract' checkbox when you ran the match?

[rjdickson]

Did you verify the Match Extract specification was not affected by the import into 7.5?

Also, did you select 'Extract' checkbox when you ran the match?

[daxinz]

Thanks for all the response.

I verified: all are imported into QS 7.5 designer from QS 7.0.
All the setings: check box selection, file definition, Cutoff ... are the same.

I have the extract file MATCH for match and get the records. But the extract file DUPA for dup fom source file A has no records. In QS 7.5 the DUBA has records.
Same as MATCH file, I defined the variables in DUPA:
Primary Key of the data in File A
Primary Key of the data in file B
The linkage weight of match
The pass number.

Thanks