COUNTY name

kogads · Post by **kogads** » Fri Jan 15, 2010 12:35 pm

Hi All,
Is there a way to asign county name for the given address record in QualityStage?

Thanks in advance.

JRodriguez · Post by **JRodriguez** » Fri Jan 15, 2010 1:55 pm

Well .... The Country Rule set provides the two letters ISO country code, if it can be resolved from your data

Dowstream, after resolving the ISO country code you should do a look up against a lookup table with ISO country codes and the country names to get the country name

kogads · Post by **kogads** » Fri Jan 15, 2010 3:07 pm

JRodriguez wrote:Well .... The Country Rule set provides the two letters ISO country code, if it can be resolved from your data

Dowstream, after resolving the ISO country code you should do a look up against a lookup table with ISO country codes and the country names to get the country name

Thanks very much for your reply but I am looking for the COUNTY NAME(not the COUNTRY NAME[/b] for the given address.

ray.wurlod · Post by **ray.wurlod** » Fri Jan 15, 2010 3:21 pm

There's nothing out of the box for county.

You could construct a lookup table perhaps based on postal code.