Exit 17 when trying to start qsrtmngr

sportclimber · Post by **sportclimber** » Fri Oct 16, 2009 5:34 pm

When starting QualityStage we normally run the following 2 commands (from the QS bin directory):

nohup ./qsserv &
nohup ./qsrtmngr &

Unfortunately, this time, qsserv is starting fine, but we're getting the following for qsrtmngr:

[1]+ Exit 17 nohup ./qsrtmngr

Has anyone else ever encountered this, and is there a resolution for this issue?

Thanks much!

chulett · Post by **chulett** » Fri Oct 16, 2009 11:03 pm

Does anyone know where these QS exit / error codes might be documented?

sportclimber · Post by **sportclimber** » Mon Oct 19, 2009 6:47 am

After approx 5 hours, I was successfully able to restart the qsrtmngr without issue. I had done nothing in between. Perhaps there was some non-obvious process running that died on it's own in between, similar to what happened as documented in this post: viewtopic.php?t=98208

I would still be interested if anyone knows where the exit codes are documented.

thanks.