I modified a standardization QStage job. Added two extra columns to be o. When I run the QS job it runs as expected. However, when I run the sequencer that calls the QStage job. I get the error below. The sequencer didn't change but I recompiled it just in case.
Sqnc1DailyHHStgExt..JobControl (@QS_STANALL): Executed: /edw/di/ext/Edw1Dev/script/ExQsJobs HHDAILY STANALL
Reply=0
Output from command ====>
stty: tcgetattr: A specified file does not support the ioctl system call.
ERROR: osh is unavailable. Please install or configure
Op Failed osh (1)
/edw/di/proj/Edw1Dev
osh is unavailable. Please install or configure
-
- Participant
- Posts: 15
- Joined: Fri Mar 09, 2007 8:22 am
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
-
- Participant
- Posts: 15
- Joined: Fri Mar 09, 2007 8:22 am
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
osh (Orchestrate shell) is the underlying architecture required for parallel execution. It lives in a directory called something like /.../DataStage/PXEngine/bin
Its parent directory must be visible on all machines mentioned in the configuration file. The configuration file's pathname is specified by the environment variable APT_CONFIG_FILE.
Its parent directory must be visible on all machines mentioned in the configuration file. The configuration file's pathname is specified by the environment variable APT_CONFIG_FILE.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 15
- Joined: Fri Mar 09, 2007 8:22 am
I checked it and the bin directory is visibleray.wurlod wrote:osh (Orchestrate shell) is the underlying architecture required for parallel execution. It lives in a directory called something like /.../DataStage/PXEngine/bin
Its parent directory must be visible ...
/edw/di/home/Ascential/DataStage/PXEngine] $ ls -ltr
drwxr-xr-x 2 dsadm dstage 4096 May 01 2006 bin
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
-
- Participant
- Posts: 15
- Joined: Fri Mar 09, 2007 8:22 am
More information. I deployed the QS job in File Mode. After talking with the contractor who wrote the application. I should've deployed the job in Parallel Extender mode. Once I re-deployed it in, Parallel mode, I still received the error. I've narrowed it down to the QS job because I ran a Dstage job on the same box and didn't get the osh error.
-
- Participant
- Posts: 15
- Joined: Fri Mar 09, 2007 8:22 am