DSXchange

Hi All,

We just came across this error too and it turned out to be one of the developers sending the .op file to the server in binary mode instead of ascii thereby leaving in control characters.

Hope that helps someone someday.

Lee

I suppose in this case we are operating with near-zero tolerance. We want to halt the sequence and treat it like a failure as far as investigation and remedy goes but with the option to continue from where we left off if that is suitable, rather than reprocess the job again unneccessarily. Perhaps w...

Thanks Craig, I was afraid that might be the answer.

I'm a little surprised that nobody else has wanted to code for this scenario before so will leave the topic open for a few days in case someone has a brilliant idea.

Cheers,

Lee

Hi All, I have a master sequence which calls a number of inter-dependent subsequences. Each of these subsequences loads a target table. If there are any warnings in the subsequence jobs we would like running jobs to complete but then halt the sequence for investigation before restarting. Since the s...